In the printing process of non-woven printing machine, safety printing is a problem that people are more concerned about, so what should we pay attention to in the safe operation of non-woven printing machine?
1. Work clothes, labor insurance shoes and work caps must be worn before starting work; it is strictly forbidden to wear ornaments, rings, watches, etc.; check the status of the equipment and whether the safety shutdown facilities are normal before operation; turn on the power switch and turn on the compressed air switch to check the button status of the equipment correct; check that the induced air and cooling water temperature systems are functioning properly.
2. Reset all the buttons of the equipment; press the switch of the pressure roller, the rubber roller is locked; turn off the electric switch and compressed air.
3. Use special materials, and use professional anti-cut gloves to polish the scraper; when starting the equipment, you need to whistle to notify the relevant personnel; during the operation of the equipment, you cannot touch the guide roller with your hands and do not wear gloves to scrub the ink at both ends; you want to adjust it after starting the machine. The scraper or pick line must be handled by the machine; foreign matter on the rubber roller must be stopped during operation; when the paper fails to connect, do not pull the partition film by hand; the upper and lower imprinting rollers need several people to load and unload at the same time to input the correct layout; clean up at any time Ink on the ground to avoid the operator from falling.
Video Introduction
The following is the operation flow of non woven ci flexo printing machine.
The following is the operation flow of non woven stack flexo printing machine.
